Marantz 5411 10470 007M Manuel d'utilisateur télécharger pdf (Page 48)

ENGLISH

Remote control

Operating range of the remote control

Point the remote control at the remote sensor when operating it.

30°

Approx. 23 ft /7 m

NOTE

The set may function improperly or the remote control may not

operate if the remote control sensor is exposed to direct sunlight,

strong artiﬁcial light from an inverter type ﬂuorescent lamp or infrared

light.

Inserting the batteries

q Slide the rear lid in the

direction of the arrow and

remove it.

w Load the two batteries

properly as indicated by

the marks in the battery

compartment.

R03/AAA

e Put the rear cover back on.

If the battery level is low, the remote control signal transmission/

status display ﬂashes 5 times when a button is pressed.

In this case, replace the batteries soon.

•If the batteries are completely exhausted, the remote control signal

transmission/status indicator goes dark.

NOTE

•Insert the speciﬁed batteries in the remote control.

•Replace the batteries with new ones if the set does not operate

even when the remote control is operated close to the unit. (The

supplied batteries are only for verifying operation.)

•When inserting the batteries, be sure to do so in the proper direction,

following the q and w marks in the battery compartment.

•To prevent damage or leakage of battery ﬂuid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not attempt to charge dry batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in

ﬂames.

•Do not keep the battery in a place exposed to direct sunlight or in

places with extremely high temperatures, such as near a heater.

•If the battery ﬂuid should leak, carefully wipe the ﬂuid off the inside

of the battery compartment and insert new batteries.

•Remove the batteries from the remote control if it will not be in use

for long periods.

•Used batteries should be disposed of in accordance with the local

regulations regarding battery disposal.

Remote control settings (remote control side)

Switches when this unit remote control operates another

MARANTZ BD players in the vicinity.

Set the remote control code simultaneously on the unit, too

(vpage37 “Remote ID”).

GRemote control code settingH

•The supplied remote control has two remote control code settings:

BD 1 and BD 2.

•The code is set to “BD 1” at the factory.

•To set the code to “BD 2”, hold the 2 and the Number button (2)

pressed for more than ﬁve seconds.

•To set (return) the code to “BD 1”, hold the 2 and the Number

button (1) pressed for more than ﬁve seconds.

If the signal code of the remote control does not match the signal

code of the unit, the remote control code set on the unit is shown on

the display.

GExampleH

If the code setting on the unit is “BD1”, and the setting on the remote

control is “BD2”, “BD1” is shown on the display.

NOTE

•Match the signal code of the remote control with the signal code of

the unit. If the remote control code is different, you cannot operate

the this unit with the remote control.

1.UD5005U_ENG_0930.indd 44 2010/10/04 18:00:37

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Marantz 5411 10470 007M Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de Blu-Ray Marantz 5411 10470 007M