Marantz RC5000 Manuel d'utilisateur télécharger pdf (Page 35)

Programming Properties

• RC5/6: click on this button to define an RC5 or RC6 IR code. RC5 and RC6 codes are shown

in the action list preceded by a [C]. RC5/6 codes control equipment from Marantz, Philips and

many other manufacturers.

• RC-MM: click on this button to define a basic mode RC-MM IR code. RC-MM codes are

shown in the action list preceded by a [C]. RC-MM codes control Philips based Infrared key-

boards for personal computers.

• Learn IR: click on this button to learn an IR code using your RC5000 connected to your PC.

Learned IR codes are shown in the action list preceded by a [C]. Here’s how to learn an

Infrared command from the component’s original remote control:

a. Connect one end of the RC5000 serial cable to your RC5000 and connect the other end

to a serial port of your PC.

b. Click on the Learn IR button.

c. Press the button on the original remote while pointing it at the learning sensor on your

RC5000. RC5000 Setup will return with one of these three replies:

Learning completed successfully

The learned code has been put on the list of actions. Press the OK button to close the

button property sheet and assign the code to the selected button.

Learning failed (timeout)

RC5000 Setup successfully connected to your RC5000, but somehow couldn't learn

the code.Try again and if it still doesn't work, refer to your RC5000 user guide to trou-

bleshoot IR code learning.

RC5000 not connected or not responding

You can click on Details>> button to open a window listing all serial ports on your

PC.

• If another application is using the serial port to which your RC5000 is connected,

you can either try another serial port or have the other application release the

serial port.

• If RC5000 Setup could open the serial port, but still could not connect, check to

see if both ends of the cable are properly inserted and if RC5000's batteries are

ok.Then wait a few seconds and try again. If after a number of tries RC5000

Setup still cannot connect, try resetting your RC5000, wait until it beeps twice

and try one more time.

Double click on a delay in the action list

to change the amount of delay.

Type in the amount of delay you want,

from .1 second to 99.9 seconds.

Press the ENTER key on your

keyboard to set the delay.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 61 62

Pas de commentaire

Marantz RC5000 Manuel d'utilisateur Page 35