Marantz SR6001 Manuel d'utilisateur télécharger pdf (Page 41)

ENGLISH

SUB W LEVEL:

Set the effect level of the subwoofer speaker

between –18 and +12 level in 0.5 level interval .

• If “NONE” was selected for the subwoofer speaker

setting in the SPEAKER SIZE, then this setting will

not appear.

Note:

• Setting to a mode other than multichannel stereo or

CSII will affect the speaker level as explained in “2-2

MANUAL SETUP”.

After you complete this portion of the setup, move the

cursor to “RETURN” with the 3, 4, 1 and 2 cursor

buttons and press the ENTER button to go to the 3.

SURR SETUP menu.

3-4 NEO:6 PARAMETER

The DTS NEO:6 mode enables a maximum 6.1

channel output with just 2 channel input. (It also

supports 5.1 channel input.)

This mode expands the sound image from the center

channel.

Select “3. SURROUND SETUP” from MAIN

MENU with the 3

4 cursor buttons and press

the ENTER button.

Select “NEO:6 PARAMETER” with the 3

cursor buttons.

Press the ENTER button to enter the

selection.

NEO:6 PARAMETER

CENTER GAIN : 0.3

RETURN NEXT EXIT

Set the CENTER GAIN level between 0.0 and

1.0 in 0.1 level

increments

with the 1

2 cursor

buttons.

After you complete this portion of the setup, move

cursor to “RETURN” with the 3, 4, 1 and 2 cursor

buttons and press the ENTER button.

Notes:

• This parameter can only be set in the NEO:6-Music

mode.

• If “NONE” was selected for the center speaker

setting in the SPEAKER SIZE menu, this setting is

disabled.

3-2 PL

x (PRO LOGIC

x) MUSIC PARAMETER

Pro LogicIIx-Music mode creates a rich and

enveloping surround ambience from stereo sources

such as CDs.

In this mode, the SR6001 includes three controls to

ﬁ ne-tune the sound ﬁ eld as follows.

Select “3. SURR SETUP” in MAIN MENU with

4 cursor buttons and press the ENTER

button.

Select “PL

x MUSIC PARAMETER” with the 3

4 cursor buttons.

Press the ENTER button to enter the

selection.

PL x MUSIC PARAMETER

PARAMETER :DEFAULT

PANORAMA :OFF

DIMENSION : 0

CENTER WIDTH: 3

RETURN NEXT EXIT

PARAMETER:

Select “DEFAULT” or “CUSTOM” with the 1 or 2

cursor buttons.

If you select “CUSTOM”, you can adjust three

parameters as listed below.

PANORAMA:

Select the PANORAMA mode “ON” or “OFF” with

the 1 or 2 cursor buttons.

Panorama wraps the sound of the front left and right

speakers around you, for an exciting perspective.

DIMENSION:

Set the DIMENSION level between 0 and 6 level in

1 level intervals with the 1 or 2 cursor buttons.

Adjust the sound ﬁ eld either towards the front or

towards the rear.

This can be useful to help achieve a more

suitable balance from all the speakers with certain

recordings.

CENTER WIDTH:

Set the CENTER WIDTH level between 0 and 7 in

1 level intervals with the 1 or 2 cursor buttons.

Center width allows you to gradually spread the

center channel sound into the front left and right

speakers.

At its widest setting, all the sound from the center

is mixed into the left and right speakers.

This control may help achieve a more spacious

sound or a better blend for the front image.

If “NONE” was selected for the center speaker

setting in the SPEAKER SIZE menu, this setting

cannot be selected.

After you complete this portion of the setup, move

cursor to “RETURN” with the 3, 4, 1 and 2 cursor

buttons and press the ENTER button.

3-3 CS

PARAMETER

Select “3. SURROUND SETUP” from MAIN

MENU with the 3

4 cursor buttons and press

the ENTER button.

Select “CS

PARAMETER” with the 3

cursor buttons.

Press the ENTER button to enter the

selection.

CS PARAMETER

TRUBASS : 0

SRS DIALOG : 0

RETURN NEXT EXIT

TRUBASS:

Set the TRUBASS level between 0 and 6 in 1- level

increments with the

1 or 2

cursor buttons.

TRUBASS produced by the speakers are an octave

below the actual physical capabilities of the speakers

adding exciting, deeper bass effects.

SRS DIALOG:

Set the SRS DIALOG level between

0 and 6

in 1-

increments

with the 1 or 2 cursor buttons.

This can be popped out of the surround audio

effects, allowing the listener to easily discern what

the actors say.

If “NONE” was selected for the center speaker

setting in the SPEAKER SIZE menu, this setting

cannot be selected.

After you complete this portion of the setup, move

cursor to “RETURN” with the 3, 4, 1 and 2 cursor

buttons and press the ENTER button.

Note:

• This parameter can only be set in the CSII mode.

SR6001N DFU_1_ENG 2_4.indd 37SR6001N DFU_1_ENG 2_4.indd 37 06.12.21 3:10:58 PM06.12.21 3:10:58 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Marantz SR6001 Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Marantz SR6001